How To Perform XPI Installation - Locally
Objectives
XPIs are software add-ons that can be installed on Xtreme PC devices in order to enhance the device capabilities. The following article provides a step-by-step description of local XPI installation.
Procedure
XPI Installation Cycle:
- Extract and deploy the XPI files to an FTP server by using the Chip PC Installer utility.
- Perform local/remote (via Xcalibur) software installation.
The XPI installation process is performed by connecting the device to an FTP server and downloading the selected XPI files.
Local XPI Installation Prerequisites:
- XPI files must already be placed on the FTP server by the Chip PC Installer utility.
- Simplifying device configuration can be done by using DHCP.
- Device Model Support: make sure the device model being used does support the XPI version you intend to install.
- Flash Space Required: every Xtreme PC has available free flash space that can be used for XPI installation. Before installing an XPI, make sure that the device has enough available free space.
- Firmware Version Support: by default, XPIs are only supported through firmware version 3.0.0 and higher. Make sure your device's firmware version supports the XPI version you intend to install.
- License Requirements: Unless specified, every XPI is license associated. An XPI without a license can be installed on the Xtreme PC device but cannot be used!
Local XPI Installation Steps:
- Enter the WBT environment.
- Select the Plugins tab and press the New button.
- SERVER NAME: type either the FTP server name or IP address.
- CREDENTIALS: Provide user credentials for FTP authentication.
- DESTINATION: type the path to the target directory on the FTP server into which XPI files were extracted by the Chip PC Installer utility.
- BANDWIDTH: define the download speed.
- Press the Next button to continue.
- Press the Browse button to retrieve the available plug-ins list from the FTP server.
- Select the XPIs you wish to install and press Next to continue.
- Press the Install button and wait for download to be completed.
- Press Finish to close the Installation Wizard.
Notes:
- Installed XPI(s) are not functional until activated. In order to locally activate an XPI enter the WBT environment -> Plug-ins tab, select an XPI and mark its corresponding check box and press OK to reboot the device.
- Please note that some XPI are configurable, activating a non-configured XPI can cause the device to be inaccessible.
Download the XPI file(s) from Chip PC web site.